Anabolic Injectable Steroids Primobolone / Primobolan Depot 100mg
Chemical Name: 17beta-Hydroxy-1-methyl-5alpha-androst-1-en-3-one, 1-methyl-1(5-alpha)-androsten-3-one-17b-ol
Molecular Weight: 414.621 g/mol
Half Life: 10 days (Enanthate), 2 – 3 days (oral)
Detection Time: 4 – 5 weeks
Anabolic Rating: 88
Androgenic Rating: 44 – 57
Common Recipe For Primobolan / Methenolone Acetate
Oil base Recipes of 100mg/ml Methenolone acetate
100mg/ml -100 gram Methenolone acetate powder (75ml)
20ml BA (2%)
200ml BB (20%)
Primobolan Cycles and Use
Primobolan cycles are commonly in the form of fat loss and/or cutting cycles. It is almost never used as a bulking or mass-gaining agent, and most of its use is in the form of a pre-contest drug in the final weeks leading up to a competition show or photo shoot. It is typically cycled with other compounds that hold similar qualities, properties, and half-lives. Many bodybuilders often stack Primobolan with Testosterone Propionate (or Testosterone Enanthate) and use it for the first 8 weeks of a cycle in order to assist in the retention of muscle mass during periods of low caloric intake.
Injectable Primobolan (Methenolone Enanthate): Medical prescription guidelines for the injectable variant of Primobolan called for an initial dose of 200mg, followed by 100mg weekly for the duration of therapy. Depending on the medical condition being treated, Primobolan doses can land anywhere in the range of 100mg every 1 – 2 weeks or 200mg every 2 – 3 weeks. There exist no separate medical dosing guidelines for female patients.
Oral Primobolan (Methenolone Acetate): Medical prescription guidelines for the oral variant of Primobolan were that of 100 – 150mg per day for no longer than a 6 – 8 week period. Just as with the injectable Primobolan prescription guidelines, there are no separate instructions for female Primobolan doses.
Primobolan dosage and administration depends heavily upon which form is being used: oral or injectable. Medical prescription Primobolan dosages outline 200mg as a first dosage, followed with 100mg every week for the complete duration of therapy. The medical condition being treated would determine what the actual full Primobolan dosage is. The range can be anywhere from 100mg every one or two weeks to 200mg every two to three weeks. Medical guidelines for oral Primobolan dosages call for 100 – 150mg per day for no longer than 6 – 8 weeks of consistent use.
The normal dosage for the injectable primobolan is 600-800 mgs per week, being pointless anything below 200 mgs. Some experienced bodybuilders experiment with higher dosages, but in such case close attention must be paid to ancillary drugs and PCT.
Regarding oral primobolan, a daily dose of 75-100 mgs should suffice to give noticeable results.
Normal cycle duration is 8 weeks for the oral, and 12 weeks for the injectable primobolan.
Primobolan is a very weak anabolic steroid and therefore impressive lean muscle and mass gains with Primobolan should not be expected. Even higher and higher doses of Primo will not elicit the same types of lean mass gain that a miniscule dose of a very powerful anabolic steroid like Trenbolone would provide, for example.
Therefore, Primobolan is often stacked alongside other anabolic steroids, and many experienced anabolic steroid users would never utilize Primobolan solitarily on its own as it is well known as being a very poor anabolic steroid to be run on its own. With all of this being established, Primobolan’s gains in and of itself is known to be quality lean muscle gains without the added water retention or possible fat gain/retention.
Dosage for Person:
1) For men:
Injectable dosages should be 600-800mgs per week or higher; Oral dosages should be around 75-100mgs per day.
2) For women:
I suggest using only oral primobolan.
Around 10mgs per day seems to be a good amount to start with. You should play with the dosage but never go over 20mgs per day.
Let’s together make primobolan depot injections.If my customers want to get 50 vials primobolan depot100,that means the concentration is 100mg/ml and the specification is 10ml/vial.If so,he need to prepare 50g methenolone enanthate powder to make 500ml liquid.At the same time,we need to use BB,BA,grape seed oil to dissolve powder by using chemical equipments.After totally dissolving it,you need to filter it and inject by whatman syringe.
Welcome to contact: